End grain sealer

PRODUCT DESCRIPTION
The product is intended for sealing cross-sections in order to protect them from cracking and wetting. The wax does not allow water to penetrate into the wood, at the same time it does not close it, it allows it to breathe freely.
The release of sap through the crossbars is reduced. The product is transparent, so it can be used universally.

RECOMMENDED PURPOSE
It can be used for the edges of terraces, roofs, roof coverings, paneling and other structures. Suitable for hardwood, softwood and exotic wood (eg bangkirai, masaranduba, cumaru, jatoba, etc.).

SURFACE PREPARATION
The wooden surface must be clean, dry and not frozen (humidity no more than 20%). Osmo cross-edge sealing wax is ready to use, do not dilute. Good for use before use. The final surface finish depends on the properties and characteristics of the wood. We recommend that you perform a trial application to ensure satisfactory results.

APPLICATION METHODS
Apply liberally to the ends with the Natural Bristle Brush. To achieve optimal protection for highly absorbent crosspieces, we recommend applying the sealing wax twice wet on wet or applying a second coat after drying.

DRYING TIME
It dries in approximately 3-4 hours under normal conditions (23°C and 50% relative humidity). Lower temperatures and/or higher humidity can significantly increase the drying time. Ensure good ventilation throughout the drying time.

COVERAGE
1 liter can cover 5 m2 in one layer. For comparison, 1 liter treats about 600 decking boards from both ends. The coverage of the product depends on the characteristics of the wood. All information is provided for smooth and planed/sanded surfaces. Other surfaces can significantly reduce the coating.

NOTE
Only for sealing the cross ends. Do not use on larger areas. Wipe off any excess from other areas with a cloth. The product enhances the natural shade of wood (gives a wet effect). After drying, we recommend to cover other surfaces with Osmo terrace oil.